Signed in as:
filler@godaddy.com
BLOWTHERM PACK P AR SERIES
Blowtherm High efficiency +90% Inversion flame pressurized hot water Boilers PACK-P AR 93-3500. The boiler is
constructed as per European directive 90/396CE (directive on gas) and 92/42CE (directive on efficiency) and Certified to
the PED (Pressure Equipment Directive).
Industrial Pressurized Boilers
Blowtherm PACK-P AR 3S
One-piece, three-round (two in combustion chamber), pressurized combustion boiler, equipped with large reverse-flame firebox, fully wetted firebox bottom.
Start-up condensate drain connection located on the flue case, internal water path designed to cool the front and raise the temperature of the back to reduce start-up condensate.
Features
- Boiler body made of P235GH EN10028-2 steel plate welded to full penetration.
- Cylindrical combustion chamber, welded internally and externally to the front plate and closed at the rear with fully wetted bottom.
- Smoke tubes are arranged to optimize water circulation inside and to balance heat exchange. Steel tubes are used: newly developed and highly efficient INOX steel turbulators are inserted inside.
- Steel front door coated internally with insulating insulation, provided with sealing gasket, complete with hole and plate for burner connection and flame control light.
- Boiler body cladding made of 60mm-thick mineral wool mat with aluminum support.
- External protection made of pre-painted galvanized sheet metal panels.
- Control and safety equipment complete with wiring and grouped in an instrument panel located above the generator and includes: dial thermometer, service thermostat, manual reset safety thermostat, main switch, protection fuse.
Industrial Pressurized Boilers
Blowtherm PACK-P AR 4S
Blowtherm High efficiency inversion flame pressurized hot water Boilers PACK-P IC 110 – 640. The boiler is constructed as per European directive 90/396CE (directive on gas) and 92/42CE (directive on efficiency) and Certified to the PED
(Pressure Equipment Directive).
SPECIFICATION
- Three passes steel heating boiler
- Steel boiler with total inversion flame combustion chamber
- Furnace with passing flame with wet back
- Low temperature working: min inlet water temperature 15°C (using gas) and
- 45°C (using oil)
- Tabulators in stainless steel AISI 430, with special configuration for high efficiency
- Easy maintenance thanks to the big front door and to the bolted smoke chamber totally dismountable
- Thermo-insulation for combustion chamber in mineral wool
- Door with refractory thermo-insulation and flame sight glass
- Pre-coated steel cover
- LOW NOx version • Suitable for whether-compensated flow temperature working
- Control panel with general switch with working lamp and thermal fuse, regulation thermostat, safety thermostat with manual reset, water dial thermometer
- Max working pressure: 5bar
- Max working temperature: 115°C
- Output efficiency 106%